DaySequerra M4.2Si AM-FM - Manual (Page 7)

7
M4.2Si User Manual
Unpacking and Installing the M4.2Si
Immediately upon receiving your M4.2Si, please make a careful inspection for any shipping damage. If
damage is found or suspected, please notify the carrier at once and then contact your dealer
.
The
DaySequerra M4.2SI is shipped in one carton, which contains: the M4.2Si unit, an AC power cable, a
Torx
TM T-8 L-key and this User Manual.
We strongly encourage you to save the shipping carton and shipping materials supplied with
your M4.2Si. They are specially designed to properly protect your M4.2Si, and in the event that you
need to return it for service, only these OEM shipping materials can ensure its safe return to our
factory.
We provide a limited 3-year warranty on all of our products, but if you don’t register your unit, it’s hard
for us to contact you when software updates become available. So please take a few minutes to
complete the warranty registration form on our web site, www.daysequerra.com. Thank you!
Rack Mount Installation. The M4.2Si chassis has four rack mounting holes in its chassis and has
been designed to fit in a 19” standard 1RU space. Plastic ‘finishing’ washers are recommended to
protect the painted finish around the mounting holes.
Power Connection. The AC power cable supplied with the M4.2Si must be connected from the
M4.2Si’s IEC320 power entry module to an AC mains outlet with a functional earth ground connection.
The M4.2Si has been set at the factory to operate at 120VAC unless otherwise specified on the
shipping carton. The M4.2Si export version is configured for 240VAC operation. Please connect your
M4.2Si to an uninterruptible power supply (UPS) to protect against power surges and
brownouts.
Antenna Input Connections. Separate 75ohm F-type connector is provided on the M4.2Si rear panel
for dedicated AM and FM antennas
Audio Output Connections. Analog audio left and right outputs are on rear-panel XLR connectors
with pin 1 GND, pin 2 + and pin 3 -. The digital audio output is transformer-isolated in S/PDIF format on
a rear-panel XLR connector with pin 1 GND, pin 2 XFMR and pin 3 XFMR. The M4.2Si digital audio
output is 5.1 surround capable.
Ethernet Connection - The M4.2Si Ethernet Port offers the use of DaySequerra’s Webserver by
connecting the M4.2Si to any networked computer with Internet access. The use of crossover cables
can be used in areas where a network connection is not possible. More information on the Webserver
can be found at the end of this manual. The Ethernet port with the aid of the webserver will keep the
M4.2Si up to date on all Firmware upgrades by checking, downloading and installing with the click of
the ‘Check Firmware’ button on the webserver. (An Internet connection must be available for ‘Firmware
Upgrade’ to work. UPON RECEIVING THE UNIT IT IS ENCOURAGED TO ‘CHECK FIRMWARE’
FROM THE WEBSERVER TO BE SURE YOUR M4.2Si IS USING THE MOST RECENT FIRMWARE
AVAILABLE.