DaySequerra M4.2Si AM-FM - Manual (Page 19)

19
M4.2Si User Manual
Network Tab
Figure 15.
• Network Settings - Configures network connections. DHCP is enabled by default.
Slide the switch to the right box to disable DHCP. IP Address, IP Subnet, Gateway are
set here. MAC is read only. After the Network settings are saved the M4.2Si will reset
itself so the new network settings are enabled.
• Private FTP Settings – An optional private FTP may be setup for firmware updates. By
default this feature is disabled. Slide the switch to the left indicated in orange to Enable
private FTP.
• Email Notifications Settings - configures the M4.2Si for email alerts when Alarm
conditions become active. This feature is set to disable by default. Slide the switch to
the left indicated in orange to enable. Entering the SMTP IP, Port, User Name,
Password, Sender, and Receiver is required. Click ‘Save’ when finished. *Password is
case sensitive alphanumeric. No spaces or symbols may be used. Pressing ‘Test’ will
Network Settings Private FTP Settings Email Settings