DaySequerra Mono2Stereo - Manual (Page 9)

M2S
User
Manual
9
Rear
Panel
AES INPUTS - Four 75Ω BNC connectors will accept an AES3 digital audio stream.
AES OUTPUTS - Four 75Ω BNC connectors output the synthesized stereo AES3 digital audio stream.
AES SYNC - Two 75Ω BNC connectors that allow Mono2Stereo to receive an AES REF or DARS clock
signal from an external source and pass it on to other devices in the same stack.
The AES-3id-1995/SMPTE 276M standard dictates a 75Ω unbalanced connection and requires
proper termination. The termination should occur at the destination of the signal (that is, on the
inputs to Mono2Stereo). If the loop-through BNC connectors are not feeding additional
equipment, terminate each of these with a standard 75Ω terminator. Like other inputs, AES
SYNC signal should be terminated.
ANALOG INPUTS – DB25 Female port to connect and process a balanced analog signal from older
equipment. TASCAM format cables are to be used.
ANALOG OUTPUTS – DB25 Female port to connect and output a balanced analog signal to older
equipment. TASCAM format cables are to be used.
NETWORK - Used to update Mono2Stereo’s firmware. To connect directly to a PC without use of a
network switch or hub, a crossover cable is required. Firmware Upgrading is accomplished via UDP
port 44600.
PSU 1 - IEC320 port to connect to AC Mains. The internal power supply is auto switching and will work
on 120VAC-60Hz or 240VAC-50Hz electrical power systems with a maximum total current draw of 25W
(>.25A 120VAC or >.15A 240VAC).
DB-25 Female Ports
on rear panel for Analog I/O.