Da-Lite IDEA Panoramic - Manual (Page 9)

9
Steps 3-8 require at least four people. Place one person on the
far left end of the screen, one person at the left panel seam,
one person at the right panel seam and one person on the far
right end of the screen. More people can be utilized as
needed. When lifting the screen off of the clean work area to
the wall and then onto the wall, it is crucial that the screen
remain coplanar and does not bend at the seams.
CAUTION: Any bend between the three panels at the seams
may damage the screen or result in a permanent gap
between the seams.
3. Using all four people, carefully lift the fully assembled three panel
screen to an upright position and then place back on the clean
work area with the viewing surface of each panel facing up.
4. Align the center panel tray section with the center panel ensuring
the tray edges align with the panel seams.
5. Secure the center panel tray section to the center panel with the
provided #8 x 1/2” screws (Figure 8).
6. Repeat Steps 4-5 to attach the left and right tray sections to the
left and right panels.
NOTE: Straight and even alignment of the tray sections will
maintain rigidity of the screen assembly when installed on the
wall.
Wall Mounting for Panoramics with Full Length Marker Tray (continued)
Viewing Surface
Aluminum Tray #8 X 1/2" Screws
Figure 8