Da-Lite IDEA Panoramic - Manual (Page 8)

8
Figure 7
Wall Mounting for Panoramics with Full Length Marker Tray
NOTE: The screen is shipped with four wall brackets and lengths
shipped vary by screen size. Two brackets will be used on the
center panel and one bracket on each of the side panels.
Measure gap on each side panel to determine which two
brackets will be used with these panels. These brackets will be of
an equal length. The remaining two brackets (also of an equal
length) will be used to hold the weight of the center panel. Use
appropriate mounting hardware for the wall type and to
accommodate for the screen’s total hanging weight.
1. Secure the two center panel wall brackets to wall studs at the
desired height. The outside edge of each wall bracket must be no
greater than 5” away from the left or right panel seams. You will
need at least 1” clearance above the drilled holes to hang the
screen.
2. Secure the two side panel wall brackets to wall studs at the
height selected in Step 1. Each side panel wall bracket should be
centered between the seam brace and left or right outside edge
of the frame when mounted to the wall (Figure 7).
NOTE: Do not proceed if all four brackets are not level with each
other or a gap may appear between each of the panels when
mounted.
Wall Brackets
No More
than 5”
No More
than 5”
Screws (Not Supplied)