Custom Autosound Secretaudio SST - Manual (Page 8)

8 7
INSTALLATION
Before you begin, always disconnect the
battery negative terminal.
Important Notes
• Before final installation, test the wiring
connections to make sure the unit is con-
nected properly and the system works.
• Use only the parts included with the unit
to ensure proper installation. The use of
unauthorized parts can cause malfunctions.
• Consult with your nearest dealer if instal-
lation requires the drilling of holes or other
modifications to your vehicle.
• Install the unit where it does not interfere
with driving and cannot injure passengers if
there is a sudden or emergency stop.
• Avoid installing the unit where it will be
subject to high temperatures from direct
sunlight, hot air, or from a heater, or where
it would be subject to excessive dust, dirt or
vibration.
• This system requires a minimum of 2
speakers (one speaker for each right and
left channel) If you only have a location for
one speaker our DVC (dual voice coil)
speaker can be used. Do not connect any
of the speaker leads to each other or
vehicle ground.
• System requires 12 volt negative ground.
• Blue power antenna lead is for 12volt
possitve trigger of optional amplifers or
power antenna relay. Do not connect to any
accessory that requires high current. If your
vehicle is not equipped with automatic
antenna or amplifiers tape this lead off.
WIRE CONNECTIONS
COMMANDER