Clay Paky SHOW BATTEN 100 AS - Manual (Page 14)

14 SHOW BATTEN 100
CONTROL PANEL
Connections to the power mains
- Fig. 6
DMX 512
DMX 512
5 PIN
Power Supply
6
7
Connections to the control signal line (DMX)
- Fig. 7
Use a cable conforming to specifications EIA RS-485: 2-pole twisted, shielded, 120Ω characteristic impedance, 22-24 AWG, low capacity. Do not use
microphone cable or other cable with characteristics differing from those specified. End connections must be made using XLR type 3-pin male/female
connectors. A terminating plug must be inserted on the last projector with a resistance of 120 (minimum 1/4 W) between terminals 2 and 3.
IMPORTANT:
The wires must not make contact with each other or with the metal casing of the connectors. The casing must be connected to the shield
braid and pin 1 of the connectors.
1
2
1
2
3
5
Connecting and disconnecting the power cord
- Fig. 5