Clay Paky STORMY CC - Manual (Page 15)

15
PRELIMINARY
5.1 SET-UP MENU
SET UP - DMX ADDRESS
It allows to set DMX address to be assigned to the projector, it’s possible to select a DMX address between
1 and 512.
> NOTE: In case of absence of DMX input signal, the displayed projector address flashes.
SET UP - CHANNEL MODE
It allows to set the operation mode of the projector selecting from the following:
• Standard: max 7 DMX channels occupied for “Stormy CC” / max 3 DMX channels occupied for “Stormy”.
• Xenon: max 4 DMX channels occupied for “Stormy”
• Independent: max 14 DMX channels for “Stormy CC”
SET UP - FIXTURE ID
It allows to set a “Fixture ID” to be assigned to the projector, for easier identifcation of the same projector in
an installation. It’s possible to select a “Fixture ID” between 1 and 255.
5.2 OPTIONS MENU
OPTION - DIMMER CURVE
It allows the selection of one of the following two Dimmer curves:
• Curve 1
• Curve 2
OPTION - MINIMUM TON VALUE
It allows the set the minimum “ T ON” duration of strobe flash under which it’s not possible to come down. It’s
possible to select a value between 0 and 255.
With the “ Duration” channel you set the fash duration. At every level of the DMX signal corresponds
a duration. The value “ Minimum T ON value” represents the level of the DMX channel Duration under which
the TON value does not change.
OPTION - LED MODE
It allows the selection of one of the following two methods of LEDs management
• Row: RGBW channels are independent.
• Balance: RGBW components are optimized to have a white color with maximum light output.
OPTION - SILENT MODE
It allows the selection of one of the following two alternatives:
• Standard: Maximum fans’ speed; therefore maximum noise level and maximum light output of the LEDs.
• Quiet: It reduces the fans’ speed and, as a consequence, the noise; the maximum brightness of the LEDs.
It reduces also subject to decrease according to the conditions of use (ambient temperature, used effect
type).
STORMY C71090
STORMY CC C71091