Clay Paky A.LEDA WASH K20 - Manual (Page 21)

21 A.LEDA WASH
LED ENERGY TOT
Lets you view total LED working hours.
1) Press
F - to display total and partial Watts/hour:
Total
Total LED working hours from construction to date.
Partial
LED working hours from last reset to date.
2) Press F to reset the partial counter. A confirmation appears on the
screen (Are you sure?)
3) Select YES to reset the partial counter or NO to keep the current setting
and open the next menu level.
SYSTEM VERSION
Used for displaying the software and hardware version of each board
installed in the projector.
CPU brd (CPU board)
0: PT-3f (Scheda Pan / Tilt)
1: Ld - Kxx (Scheda LED)
BOARD DIAGNOSTIC
Used for displaying the status error of each board installed in the projector:
0: PT-3f (Scheda Pan / Tilt)
1: Ld - Kxx (Scheda LED)
DMX MONITOR
Used for displaying the projector DMX channel level in bit (Val) and in
percentage (Perc).
FANS MONITOR
Used for displaying the speed of each fan installed in the projector:
PwrSp (fan PSU)
Head (fan head)
SENSOR STATUS
It lets you check the correct operations of each "sensor” installed in the
projector, each channel is associated with one of the following three
parameters:
• n.a.= sensor not available
• ON= sensor working
• OFF= sensor defective
NETWORK PARAMS
Allows the "Network" parameters of the projector to be displayed or:
IP address: Internet Protocol address (two projectors must not have
the same IP address)
IP mask: 255.0.0.0
Mac address: Media Access Control: the projector’s Ethernet Address.
RESET
Used for resetting the projector.
1) Press
F to reset the projectors, a confirmation message (Are you
sure ?) appears on the display.
2) Select YES to starting reset the fixture or NO to keep the current
setting and return to the top menu level.
CHANNEL
Used for setting channel levels from the projector control panel.
1) Press
F - the first channel appears on the display.
2) Use the UP B and DOWN C keys to select the required channel:
3) Press F and use the UP B and DOWN C keys to select the
required DMX level (value between 0 and 255).
4) Press LEFT D to return to the top menu level.
System
Version Board Revis. Hw.rv.
CPU brd x.x.x x.x
com.dev x.x
0: PT-3f x.x x.x
1: Ld - Kxx x.x x.x
Network
params
Dmx
Monitor
Board Status Err%
0:PT-3f Good 0.00
1: Ld - Kxx Good 0.00
Fans
Monitor
Fan Speed (RPM)
PwrSp XXXX
Head XXXX
Board
Diagnost.
Information
MANUAL CONTROL
Manual
Control
No
Yes
Reset
Channel
LED Energy
Tot
Sensor
Status
Continue ➔