Cino FA470 - Manual (Page 60)

F
u
z
z
y
S
c
a
n
F
ix
e
d
M
o
u
n
t
S
c
a
n
P
ro
g
ra
m
m
in
g
M
a
n
u
a
l
54
PROGRAM
Operation Control
FM480
♦ ♦ ♦ ♦ Operation Mode Setting ♦ ♦ ♦ ♦ F_DEFAULT
Family Code Selection P.C Parameter Selection Option Code
Operation Mode SS
SS
SS
SS
SS Trigger mode
Presentation mode
Alternative mode
Force mode
Level mode 1
2
3
5
8
Trigger Mode (External Triggering) When the scanner receives an external trigger or a serial trigger ON command under trigger mode, the scanner will turn on the light
source to read barcode until gets a good read, a serial trigger OFF command or a release of external trigger. Once the light source goes off, the scanner is waiting for the
next trigger to activate scanning again.
Presentation Mode (Auto Detection) Under presentation mode, the scanner will automatically detect the object movement in the scanner field of view. Once the scanner
detected a similar barcode image, the scanner will turn on the light source to read barcodes until the preset scan input time-out is up. For dark environments, you may
adjust the setting of “Presentation Sensitivity” to increase the detection sensitivity
Alternative Mode (Periodic Power Off) When the scanner receives an external trigger or a serial trigger ON command under alternative mode, the scanner will turn on the
light source to read barcodes until the preset scan input time-out is up. The scan input time-out will be reset after each good read. Once the light source goes off, the
scanner is waiting for the next trigger to activate scanning again.
Force Mode (Continued Power On) Under force mode, the scanner continues to read barcodes without using external trigger or serial trigger. Please note that the scanner
will not stop reading until you switch into another operation mode.
Level Mode (Auto Power Off) When the scanner receives an external trigger or a serial trigger ON command under level mode, the scanner will turn on the light source to
read barcodes until a good read is performed or the preset scan input time-out is up. Once the light source goes off, the scanner is waiting for the next trigger to activate
scanning again.