Cino FA470 - Manual (Page 10)

F
u
z
z
y
S
c
a
n
F
ix
e
d
M
o
u
n
t
S
c
a
n
P
ro
g
ra
m
m
in
g
M
a
n
u
a
l
4
Intelli Button
For normal operation, the Intelli Button of the scanner acts as a manual Trigger Switch. You can press the Intelli Button to
scan the corresponding barcode commands to configure your scanner with ease. Moreover, the useful Intelli Button can help
you to identify the best mounting position. Please refer to following descriptions for more details.
Optimize Your Installation
Once the mounting position for the scanner is determined, you may use the Intelli Button to optimize the mounting position
with ease. Please follow below procedures to use the Intelli Button.
Press and hold the Intelli Button for more than 5 seconds until the status indicator gives one green blink, then release the
button. The scanner will emit 2 short beeps and the power indicator will flash blue blink per 1 second to indicate the force
reading process is activated. The scanner will turn on the light source to scan barcodes continuously until the whole
process completed.
Keep the scanner to read the same barcode. The scanner will count the Good Read numbers, then output the
information of reading rate and refresh LED indications every 100 scans. The format of output message is listed below.
< Readout data > : < Reading rate (0 to 100) >
Meanwhile, both Status and OK/NG indicators provide the visible reading rate information as well. You may refer to the
table listed below for details.
Reading rate STATUS Indicator OK/NG Indicator
100% Steady Green Steady Green
80 to 99% Steady Red Steady Green
50 to 79% Steady Green Steady Red
20 to 49% Steady Orange Steady Orange
0 to 19% Steady Red Steady Red
If the reading rate is not good enough, please adjust the reading angle and distance to get the optimum readability. If you
would like to exit the force reading process, please press the Intelli Button once again.
1. If the scanner is unable to read any barcode during preset scan input time-out (default is 900ms), the scanner will count it as a
NG reading
2. During force reading process, the OK/NG output signals will not be Performed.