Chicago Gaming Putt! Championship - Manual (Page 9)

9
Aligning Motion Sensor
The motion sensor is aligned before you receive it, but it is possible
that some movement has occurred during shipment.
NOTE: For better visibility, use the removed back door to shield
light from the cabinet. When the back door is open, light
reflecting off the motion sensor guard tends to wash out the
image, making it more difficult to see.
Open the coin door and press the Menu button on the Service Panel.
Using the Up and Down buttons on the Control Panel, move to
Diagnostics and press Start. From this menu, select Motion Sensor.
Look at the box labeled “Live Feed.” This shows you what the motion
sensor is currently seeing.
If the motion sensor is correctly aligned, you should see equal black
triangles on both sides of the image and a thin silver line, which is the top of the Ball Gate, at the bottom
of the screen. THIS LINE MUST BE HORIZONTAL FOR THE MOTION SENSOR TO TRACK
ACCURATELY. If the image DOES NOT appear as described, use the guide below to determine
how you must adjust the motion sensor.
See Motion Sensor Test on page 19 for information on adjusting the ball speed.
BEND SENSOR
BRACKET DOWN
LOOSEN THE TWO
SCREWS SHOWN
BELOW, SWIVEL THE
SENSOR LEFT OR
RIGHT, THEN TIGHTEN
THE SCREWS
Live Feed Live Feed
Live Feed Live Feed
LOOSEN THE TWO
SCREWS SHOWN BELOW
AND TWIST THE SENSOR
SO THE WHITE LINE AT
THE BOTTOM IS
PERFECTLY HORIZONTAL.
WHEN IN PLACE, TIGHTEN
THE SCREWS
Live Feed
REMOVE BACK DOOR TO
ACCESS MOTION SENSOR
SENSOR TOO HIGH SENSOR NOT CENTERED IMAGE NOT HORIZONTAL
MUST BE PERFECTLY HORIZONTAL
PERFECT
BEND SENSOR
BRACKET UP
SENSOR TOO LOW