Chicago Gaming Putt! Championship - Manual (Page 10)

10
Accessing and Removing Computer Shelf
The computer shelf is located at the rear of the Coin Door Cabinet. The computer shelf can be accessed
by removing the door on the back of the Coin Door Cabinet. Remove the thumbscrew and slide the
computer shelf back.
There are nine cables that need to be disconnected from the Computer Shelf to completely remove it
from the cabinet. These are the Fan Power Harness, Power Cable to the Power Supply, Coin Door
Harness, Control Panel Harness, Ball Mech Harness, Speaker Harness, DVI Cable, USB Extension
Cable and the Motion Sensor’s USB Cable
1. TURN POWER OFF AND UNPLUG FROM WALL!
2. Remove the back door of the Coin Door Cabinet.
3. Disconnect the Fan Power Harness from the ATX Power Supply.
4. Remove the thumbscrew that holds the Computer Shelf in place.
5. Pull the computer shelf out just enough so that you can see all of the I/O Board and Power
Supply.
6. Disconnect the A/C Power Cable from the Power Supply.
7. Disconnect the 4 cable connectors that are attached to the face of the I/O Board. These are the
Coin Door Harness, Control Panel Harness, Ball Mech Harness and the Speaker Harness.
8. You can leave the 4-pin power connecter attached to the top of the board, as well as the USB
cable and Audio Cable.
9. Continue pulling the shelf out of the cabinet.
10. Disconnect the monitor’s DVI Cable from the Video Card that is connected to the motherboard.
11. Disconnect the Motion Sensor USB Cable and USB Extension Cable from Motherboard.