Bonaire Comfort Control - RF/LV - Manual (Page 11)

Multi-Appliance Comfort Control
Navigating the Controls
FAULT CODE RECALL
• Press & release SET TIME/PROGRAM and ENTER
simultaneously for 10 seconds to display the last fault
code.
• Use the up arrow to display the last 4 fault codes.
SETTING DAY AND TIME
After installing batteries for the first time or replacing old batteries (RF hand held model), or after a power
cut (Low voltage hard wired model), the display will indicate OFF and the day and time when the
batteries/power were last removed.
S ET T IME
Using SET TIME mode:
1. Press ON/OFF to switch the controller ON.
2. Press & hold the SET TIME/PROGRAM button for more
than 2 seconds until TIME flashes. A DAY will also flash
on the bottom row of the display.
3. Press ▲ to advance to next day or ▼ for previous days.
4. Press ENTER to select the day. The DAYS will stop
flashing and the HOURS segments will flash.
5. Press ▲ to advance to next hour or ▼ for previous hours.
6. Press ENTER to select hour. HOUR will stop flashing and
MINUTES will flash.
7. Press ▲ to advance to next minute or ▼ for previous
minutes.
8. Press ENTER to select minutes.
9. Press SET TIME/PROGRAM to exit the time setting mode
at any stage.
12/24 HOUR CLOCK
To change between the 12 hour and 24 hour clock modes
1. Press & hold the SET TIME/PROGRAM button for more
than 2 seconds until TIME flashes.
Comfort Control - PNE Page 11