Axiomtek MANO861 - Manual (Page 34)

MANO861 Mini ITX Board
26 Hardware Installation
3. Firmly insert the SO-DIMM into the socket until the retaining clips snap back in
place and the SO-DIMM is properly seated.
Important
 A DDR3 SO-DIMM is keyed with a notch so that it fits in only one
direction. DO NOT force a SO-DIMM into a socket to avoid damaging
the SO-DIMM.
 The DDR3 SO-DIMM sockets do not support DDR2 SO-DIMMs. DO
NOT install DDR2 SO-DIMM to the DDR3 SO-DIMM socket.
Caution
Make sure to unplug the power supply before adding or removing
SO-DIMMs or other system components. Failure to do so may cause
severe damage to both the motherboard and the components.
3.3.4 Removing a SO-DIMM
1. Simultaneously press the retaining clips downward to unlock the SO-DIMM .
2. Remove the SO-DIMM from the socket.
Note
Support the SO-DIMM lightly with your fingers when pressing the
retaining clips. The SO-DIMM might get damaged when it flips out with
extra force.
Locked retaining clip
Unlocked retaining clip