Avalue ECM-LX800W - Manual (Page 59)

User ’s Manual
ECM-LX800W Series User ‘s Manual 59
RxD , TxD Active
Hi,Hi
Hi,Lo
Lo,Hi
Lo,Lo
This item allows you to determine the active of
RxD, TxD level.
IR Transmission Delay
Enabled
Disabled
This item allows you to enable/disable the IR
Transmission Delay.
UR2 Duplex Mode
Half
Full
Select the value required by the IR device
connected to the IR port. Full-duplex mode
permits
simultaneous two-direction
transmission. Half-duplex mode permits
transmission in one direction only at a time.
Use IR Pins
RxD2,TxD2
IR-Rx2Tx2
This item allows you to determine the pin
definition.
Onboard Parallel Port
Disabled
378/IRQ7
278/IRQ5
3BC/IRQ7
FDD Mode
Select a matching address and interrupt for
the physical parallel (printer) port.
Parallel Port Mode
SPP
EPP
ECP
ECP+EPP
Normal
Select an operating mode for the onboard
parallel port. Select Compatible or Extended
unless you are certain both your hardware and
software support EPP or ECP mode.
EPP Mode Select
EPP1.9
EPP1.7
Select EPP port type 1.7 or 1.9.
ECP Mode Use DMA
1
3
Select a DMA channel for the port.
Watch Dog Timer Select
Disabled,
10, 20, 30, 40 Sec.
1, 2, 4 Min.
This option will determine watch dog timer
Onboard Serial Port 3
Onboard Serial Port 4
Disable
3F8
2F8
3E8
2E8
Select an address for the third and fourth
serial ports.
Serial Port 3 Use IRQ
Serial Port4 Use IRQ
IRQ5
IRQ7
IRQ10
IRQ11
This determines the IRQ in which the third and
fourth serial ports can use.