Avalue ECM-LX800W - Manual (Page 51)

User ’s Manual
ECM-LX800W Series User ‘s Manual 51
3.5.2.12 Typematic Rate (Chars/Sec)
Select ―Enabled‖ of Typematic Rate then set the rate at which a character keeps repeating
while holding down a key.
The choices: 6,8,10,12,15,20,24,30
3.5.2.13 Typematic Delay (Msec)
Select
―Enabled‖ of Typematic Rate then set the length of delay before keying strokes to
repeat.
The choices: 250, 500, 750, 1000
3.5.2.14 Security Option
To allow selecting whether the password is required every time the system boots or only
when you enter the Setup.
Item Description
Setup Require password when entering the main CMOS Setup Utility Screen only.
System Require password every time the system boots
Note: To disable security, select PASSWORD SETTING at Main Menu and then
you will be asked to enter password. Do not type anything and just press
, it will disable security. Once the security is disabled, the system
will boot and you can enter Setup freely.
3.5.2.15 OS Select for DRAM > 64MB
Select the operating system that is running with greater than 64MB of RAM on the system.
Item Description
Non-OS2 Disable OS for over 64 MB DRAM
OS2 Enable OS for over 64 MB DRAM
3.5.2.16 Full Screen LOGO Show
If the BIOS had the full screen logo in it, this item could allow enable/ disable the full screen
logo show on display.
Item Description
Enable Enable full screen logo show
Disable Disable full screen logo show
3.5.2.17 Small Logo (EPA) Show
This item allows you enabled/disabled the small EPA logo show on screen at the POST
step.
Item Description
Enabled EPA Logo show is enabled
Disabled EPA Logo show is disabled
3.5.2.18 Onboard Lan Boot ROM
This item allows to boot over the network when system POST and shorten the booting time
by set disabled
Item Description
Enabled Enable Onboard LAN boot.
Disabled Disabled Onboard LAN boot.