Austroflamm PallasBack - Manual (Page 9)

Pallas Back 7 english
Heating in-between seasons
If you heat the stove in between seasons, when the outside
temperatures are higher, the flue gases may not be able to
escape completely and this may lead to disturbances in the
chimney draught, especially if the temperatures are rising
suddenly. The stove has to be charged with less wood then
and the primary air has to be increased so that the wood
can burn down faster (with visible flames) and thus the
chimney draught can stabilize.
Chimney fire
A chimney fire may occur, due to sooting and deposits in
the chimney, if improper or humid fuel is used. In case of a
chimney fire close all air inlets on the fireplace/chimney
immediately and call the fire brigade. Please have an
expert inspect your chimney for cracks and air-tightness
after the burning out of the chimney.
4. THE MOST IMPORTANT SPARES—OVERVIEW
Gaskets
Description Nr. drawing Part number
Flat gasket 8 x 2 mm 13 710096
Round gasket 6 mm (0,5 m) 14 710696
Round gasket 14 mm (2,1 m) 15 710338
Keramott
Description Nr. drawing Part number
Bottom Keramott left 1 712766
Bottom Keramott right 2 712767
Bottom Keramott centre 3 712760
Rear, Keramott 4 712761
lateral Keramott right 6 712763
lateral Kermott left 5 712762
Keramoot baffle plate 7 712764
Keramott wood retainer 8 712765
Other parts
Description Nr. drawing Part number
Pallas door glass 10 712759
Door Handle 11 712786
BA1 spring 12 715641
Stove lacquer -- 650002
Glass cleaner ½ litre -- 640070
Accessories
You can obtain floor plates of glass or steel, care products or the Heat Memory System for heat storage from your certified
dealer
.
IMPORTANT: Have defective parts replaced by your certified dealer. This will guarantee that your stove functions
properly and safely.
The fireplae must not be attered
.
Maintenance
To clean the glass, please use a specialised product such as Thermohit glass cleaner. Lacquered surfaces are to be
cleaned only with a cloth (may be damp). Special cleaning agents should also be used for stainless steel surfaces
.
Only gaskets in good order ensure the proper function of your stove!
Cleaning
The stove, flue outlets and smoke pipes should be cleaned and inspected for deposits every year – if necessary more
often, e.g. after the cleaning of the chimney. The chimney also has to be cleaned regularly by the chimneysweeper. Your
chimneysweeper will inform you of the necessary inspection intervals. An expert should inspect the stove annually.
order of Keramott installation acc. to numbering
3
4
7
8
1
2
5
6