Austin Hughes PPS-02-S - Manual (Page 23)

www.austin-hughes.com UM-PPS-02-S-Q214V1 P.19
Step 5. Select the SNMP from the left navigation
Step 6. The SNMP Settings window appears as below:
Step 7. Click “ Enable “ in “ SNMP Agent “ to start the SNMP agent service
Step 8. Input “ Read Community “. Default is “ public ”
Step 9. Input “ Write Community “. Default is “ private ”
Step 10. Select “ disabled “ or “ V2Trap “ in “ SNMP Traps “
If select “ V2Trap “ , please input IP address of the SNMP management station in “ Station IP: “
Step 11. Click “ Apply “ to fi nish the SNMP settings
< 1.10 > SNMP Management