ADLINK IMB-M42H - Manual (Page 24)

14 Getting Started
Digital I/O Power Select (3-pin JGPIO_PWR1)
2.6 Onboard Headers and Connectors
Digital I/O Pin Header (10-pin JGPIO1)
NOTE: NOTE:
When setting "Resume from AC power lost " to "on" in BIOS, or
setting jumper to "AT mode", short PWR_LOSS1 pin next to
the PWR_JP1 if the power supply unit has slow electrical dis-
charge.
Status Connection JCLRT_C2
+12V 1 – 2
+5V 2 – 3 (default)
CAUTION:
Do not place jumper covers over headers and connectors to
avoid permanent damage.
NOTE: NOTE:
For location on board, see Section 1.3 Motherboard Topogra-
phy
Pin Signal Pin Signal
1 SIO_24 2 SIO_20
3 SIO_25 4 DSIO_21
5 SIO_26 6 SIO_22
7 SIO_27 8 SIO_23
9 JGPIO_PWR1 10 GND
1
2
9
10