ADLINK NuPRO-E320 - Manual (Page 47)

Getting Started 33
NuPRO-E320
3.3 Installing Memory Modules
The NuPRO-E320 supports up to 4 GB of DDR3 800/1066 MHz
memory modules via four DDR3 DIMM sockets. A DDR3 module
has a 240-pin footprint compared to the legacy 184-pin DDR
DIMM. DDR3 modules are notched to facilitate correct installation
on the DIMM sockets.
Memory Configuration Options
The NuPRO-E320 allows you to install 512 MB, 1GB and 2GB
unbuffered non-ECC DDR3 DIMMs into the DIMM sockets follow-
ing these configuration options:
X Channel A: DIMM1
Channel B: DIMM2
X For dual-channel configuration, the total size of memory
module installed per channel must be the same
(DIMM1 = DIMM2).
X It is recommended that you install DIMMs with the same
CAS latency. For maximum compatibility, install memory
modules with the same brand, model, and/or rating.
To install a memory module:
1. Locate the DIMM sockets on the motherboard.
2. Press the socket’s retaining clips outward to unlock.
WARNING:
Disconnect all power supply to the board before installing a
memory module to prevent damaging the board and mem-
ory module .