ADLINK LEC-BTS - Manual (Page 7)

Overview 3
LEC-BTS
Figure 1-3: Component Locations (Bottom Side)
1.3 Connectors, Switches, and LEDs
Table 1-2 describes the connectors, switches, and LEDs shown in Figure 1-4.
Table 1-2: Module Connector Description
Reference
Board
Access
Description
GF1 – SMARC P-S Top/
Bottom 314-pin, MXM edge connector for Memory, Video, and I/O
functions.
CN1 Top 40-pin, DB40 connector for debug card
SW1 Top 4-pin dip switch for selecting CSI1 camera, 4L, Data1
configuration [default=off]
SW2 Top 4-pin dip switch for selecting CSI1 camera, 4L, Data2
configuration [default=on]
SW3 Top 4-pin dip switch for selecting CSI1 camera, 4L, Data3
configuration [default=on]
SW1, SW2, SW3 Configurations:
• Camera with 1 MIPI-CSI lane = SW1-SW3 switches all set to ON
• Camera with 2 MIPI-CSI lanes = SW1 (both OFF); SW2 (both ON); SW3 (both ON)
• Camera with 3 MIPI-CSI lanes = SW1 (both OFF); SW2 (both OFF); SW3 (both ON)
• Camera with 4 MIPI-CSI lanes = SW1-SW3 switches all set to OFF
LEC_BTS_Bot_Comp_a
Key:
U9 - GbE Controller
U24 - DDR3L SDRAM
U27 - DDR3L SDRAM
U9
U24
U27
S75 S158
ON 1 2
(1 2)
LEC-BT_SW1_c
(4 3)
Switch Default Setting
ON 1 2
(1 2)
LEC-BT_SW2_b
(4 3)
Switch Default Setting
ON 1 2
(1 2)
LEC-BT_SW3_b
(4 3)
Switch Default Setting