ADLINK aTCA-9710 - Manual (Page 32)

32
4.1.5 System Firmware Progress Sensor
Sensor Type Sensor
Type
Code Sensor
Specific
Offset Event
System
Firmware
Progress
(formerly
POST
Error) 0Fh 00h
01h
02h
System Firmware Error (POST Error)
The Event Data 2 field can be used to provide an event
extension code, with the following definition:
Event Data 2
00h Unspecified.
01h No system memory is physically installed in the
system.
02h No usable system memory, all installed memory has
experienced an unrecoverable failure.
03h Unrecoverable hard-disk/ATAPI/IDE device failure.
04h Unrecoverable system-board failure.
05h Unrecoverable diskette subsystem failure.
06h Unrecoverable hard-disk controller failure.
07h Unrecoverable PS/2 or USB keyboard failure.
08h Removable boot media not found
09h Unrecoverable video controller failure
0Ah No video device detected
0Bh Firmware (BIOS) ROM corruption detected
0Ch CPU voltage mismatch (processors that share same
supply have mismatched voltage requirements)
0Dh CPU speed matching failure
0Eh to FFh reserved
System Firmware Hang (uses same Event Data 2 definition
as
following System Firmware Progress offset)
System Firmware Progress
The Event Data 2 field can be used to provide an event
extension
code, with the following definition:
Event Data 2
00h Unspecified.
01h Memory initialization.
02h Hard-disk initialization
03h Secondary processor(s) initialization
04h User authentication
05h User-initiated system setup
06h USB resource configuration
07h PCI resource configuration
08h Option ROM initialization
09h Video initialization
0Ah Cache initialization
0Bh SM Bus initialization
0Ch Keyboard controller initialization
0Dh Embedded controller/management controller
initialization
0Eh Docking station attachment
0Fh Enabling docking station
10h Docking station ejection
11h Disabling docking station
12h Calling operating system wake-up vector