ADLINK USB-3488A - Manual (Page 24)

16 Installation
2.5.2 PXI-3488 Installation Procedures
Please follow the instructions to install the PXI-3488 into your PXI
chassis.
1. Turn off the system.
2. Align the module’s edge with the card guide in the PXI
chassis.
3. Slide the module into the chassis, until resistance is felt
from the PXI connector
4. Push the ejector upwards and fully insert the module into
the chassis.
5. Once inserted, a “click” can be heard from the ejector
latch.
6. Tighten the screw on the front panel.
Turn on the computer, and install the software according to the
instructions in the Software Installation section (2.6), on page 21.
2.5.3 USB-3488A Installation Procedures
Please follow the instructions to install USB-3488A in your system.
1. Connect USB-3488A to any USB Port
2. After several seconds, the "Ready" LED become Green,
USB-3488A is ready for work.
if you use USB-3488A with a USB Hub, we suggest you to have
an independent power for the Hub.