English !6 – Denon DN-C635 User Manual
Page 7
7
ENGLISH
!6
Pitch Slider
• Use this slider to adjust the play speed. Slide
up to decrease the play speed, down to
increase the play speed.
!7
PROG. PLAY ON/OFF button
• When this button is pressed while the PROG
indicator is lit, the program play mode is set.
• The button will not function during the A-B play
mode.
• The PROG. PLAY ON/OFF LED lights during
the program play standby and play modes.
• When the button is pressed during the
program play standby or play mode, the
program play mode is cleared.
!8
PROGRAM IN button
• Press this button to set the program input
mode.
• The button will not function during the play
mode.
• The PROG indicator flashes when in the
program input mode.
• The PROG indicator lights when a program is
set.
!9
REPEAT button
• Press this to perform repeat playback.
@0
TIME button
• The time display switches each time this
button is pressed. (“REMAIN”, “ELAPSED”)
@1
TITLE button
• When the button is pressed, the text
information (Disc title, track title, disc artist or
track artits) is displayed.
• When the button is pressed while in the stop
mode with a disc containing an MP3 ID3-Tag
loaded, the file name is displayed. When
pressed during playback, the display switches
as shown below.
(2) Rear panel
q
BALANCED OUT connectors
• These are active balanced outputs using XLR
type connections. The CD’s playback signals
are output from these connectors.
• Pin layout : 1. Common / 2. Hot / 3. Cold
• Applicable connector :
Cannon XLR-3-31 or equivalent.
w
LEVEL L/R controls
• Use these controls to adjust the level of the
audio signals from the BALANCED OUT
connectors.
e
UNBALANCED OUT jacks
• These are unbalanced outputs using RCA type
jacks.
r
DIGITAL OUT jack
• This is a coaxial output using an RCA type jack.
• Signal format : SPDIF or IEC-958 Type
II
t
Serial control port
• This is serial remote connector.
• Applicable connector : 9-pin D-sub (male)
• Baud rate : 9600 bps
• Pin layout
File name of currently playing track
Elapsed time of currently playing track
Title name
Artist name
Album name
@2
FOLDER button
• When disc containing MP3 format files is
loaded, in the stop mode press this button then
the folder select mode is possible.
@3
A-B (A-B repeat) button
• Use this to play a set section repeatedly.
• When the button is pressed once during
playback, that position is set as the A point and
the “A-B” indicator flashes on the display.
• When the button is pressed again, that position
is set as the B point, the “A-B” indicator stops
flashing (remaining lit), and the A-B section
begins playing repeatedly.
• When the button is pressed again, A-B repeat
is canceled and the mode returns to the normal
play mode.
@4
Headphones jack
• For private listening, you can connect your
headphones to this jack.
@5
PHONES LEVEL control
• Use this adjust the output level of the
headphones.
NOTE :
• Do not short-circuit the hot or cold pin with
the common pin.
Pin No.
Signal Name
1
6
NC
GND
I / O
_
_
2
7
NC
TxD
O
_
3
8
NC
RxD
I
_
4
9
NC
NC
_
_
5
S. GROUND
_
RS-232C
Pin No.
Signal Name
1
6
NC
GND
I / O
_
_
2
7
TxD
TxD (RETURN)
O
O
3
8
RxD (RETURN)
RxD
I
I
4
9
NC
NC
_
_
5
S. GROUND
_
RS-422A
y
Parallel remote control port
• This is a parallel remote connector.
• Applicable connector : 25-pin D-sub (male)
• Connecting signal layout
Pin No.
Signal Name
1
14
PLAY tally
FG
I / O
_
O
2
15
PAUSE tally
PLAY command
I
O
3
16
CUE tally
PAUSE command
I
O
4
17
INDEX 2/INDEX 3 tally
CUE command
I
O
5
TRACK (+) command
I
TTL (Iol = 20mA)
TTL (Iol = 20mA)
HCMOS (Ii = 3mA)
TTL (Iol = 20mA)
HCMOS (Ii = 3mA)
TTL (Iol = 20mA)
HCMOS (Ii = 3mA)
HCMOS (Ii = 3mA)
18
Tally common
_
6
19
Reserved
TRACK (–) command
I
_
7
20
Reserved
SEARCH (Fwd) command
I
_
8
21
Reserved
SEARCH (Rev) command
I
_
9
FADER START command
I
HCMOS (Ii = 3mA)
HCMOS (Ii = 3mA)
HCMOS (Ii = 3mA)
HCMOS (Ii = 3mA)
22
Tally power supply
_
10
23
Command common
Command common
_
_
11
24
EOM tally
NC
_
_
12
25
Reserved
Reserved
_
_
13
Reserved
_
+3.3V, 20mA
(Ii = 10mA)
TTL (Iol = 20mA)