Acrosser AR-B1790 - Manual (Page 30)

29
Mouse PowerOn Function
When set to [Enabled], this parameter allows you to use the PS/2 mouse to turn on the system. This feature
requires an ATX power supply that provides at least 1A on the +5VSB lead. Configuration options: [Disabled]
[Left-button] [Right-button]
ACPI Standby State
This option will not be shown or not be available if you are using a CPU with the locked ratio.
Auto: BIOS will automatically select ACPI Suspend type
S1/POS
Set ACPI Suspend type to S1.
S3/SIR Set ACPI Suspend type to S3
USB KB Wake-Up From S3
Set this field to Enabled to use the Wake-On-USB Keyboard function. This function allows you to use a USB
keyboard to wake up a system from the S3 (STR -Suspend To RAM) state.
Power Button Function
This feature sets the function of the power button. Settings are: Power Off The power button functions as normal
power off button. Suspend When you press the power button, the computer enters the suspend/sleep mode, but if
the button is pressed for more than four seconds, the computer is turned off.
Resume On Ring
Set this field to Enabled to use the modem ring-on function. This will allow your system to power-on to respond to
calls coming from an external or internal modem.
Resume On LAN
If you are using a LAN card that supports the remote wake up function, set this field to Enabled. The will allow the
network to remotely wake up a Soft Power Down (Soft-Off) PC. However, if your system is in the Suspend mode,
you can wake up the system only through an IRQ or DMA interrupt.
5.6 PCI/PLUG AND PLAY
This section is used to configure PCI / Plug and Play features. The option configures the
PCI bus slots. All PCI bus slots on the system use INTA#, thus all installed PCI cards must be set to this value.
PCI / Plug And Play