beautypg.com

Error (beep) codes & index, 1 error (beef) codes, 2 index – Acrosser AR-B1042 User Manual

Page 33

background image

AR-B1042 User

s Guide

5-1

5. ERROR (BEEP) CODES & INDEX

5.1 ERROR (BEEF) CODES

There are three possible beep codes produced by the BIOS during POST listed below:

Beep Code

Error Condition

1 long followed by 2 short beeps

CMGA card failure

1 long followed by 3 short beeps

RAM test failure

1 long followed by 4 short beeps

DAC test failure

1 long followed by 8 short beeps

VGA initialized failure

Table 5-6 Error (Beef) Codes

If you have problems after installation, check the following to determine the cause.

1. Ensure that all cable are properly connected, all plugs are firmly seated in their sockets. Check to see if the

VGA and LCD is firmly seated in its bus PC/104. Be sure it is not making contact with any other cards in
the system.

2. Ensure that the display monitor is properly connected to computer. Be sure the display monitor and your

system’s power supply is operating properly (i.e. FAN operates, system power light come on). Power OFF
the computer system and all other connector devices before checking the following:

3. Ensure that the system motherboard switch’s/jumper(s) are set properly for use with the VGA board.

4. Ensure that no other switch setting on the CPU card have been accidentally change. Refer to the

documentation provided with you computer to determine the corrector switch settings.

5. Be sure the CLMODE.EXE setting match you monitor frequency.

6. Ensure the LCD panel’s VEE and BACKLIGHT voltage (adjust VR)


If checking these items does not locate the problem, there may be a malfunction of the computer system, display
monitor or the VGA and LCD board. Consult you computer dealer for assistance in locating the problem.

5.2 INDEX

Name Function

Page

CON1

Universal panel connector

2-3

CON2

10-pin VGA monitor connector

2-3

CON3

Panel power connector

2-3

CON4

40 pin PC/104 connector bus C & D

2-4

CON5

64 pin PC/104 connector bus A & B

2-4

J1 & J2

Linear address select

2-6

J3 Clock

select

2-6

J4 Panel

select

2-6

J5

BIOS bank select (set panel type)

2-7

U1 BIOS

Flash

U4 & U5

RAM socket

Table 5-7 Index