Acrosser AR-B1042 User Manual
Page 28
AR-B1042 User
s Guide
4-6
4.1.7 Windows NT
These drivers are designed to work with Microsoft Windows NT 3.5x.
Step 1 :
Install Windows NT as you normally would for a VGA display. Run Windows NT Control Panel from
the Main Group. Choose the Display option. In the Display Settings dialog box, click on Change
Display Type. Click on Change from the Adapter Type in the Display Type dialog box. Click on
Other in the Select Device dialog box.
Step 2 :
Place the Windows NT Display Driver Diskette in drive A. Press
of the driver:
CHIPS Video Accelerator (65545,65548)
CHIPS Video Controller (65510,65530,65535,65540)
Will appear highlighted in the Models list box. Click on INSTALL to install the selected driver. Once
the installation is complete, the system must be shut down and restarted.
Step 3 :
Upon restart, at the Invalid Display Selection message, click on OK and select the desired display
settings from the Display Settings dialog box. Click on Test to test the newly selected graphics
mode. A color test screen should appear, followed by the Testing Mode window. Click on Yes to
continue. The Display Settings Change windows will appear. Click on Restart Now for the new
settings to take effect.
4.2 THE CHIPSDSP UTILITY PROGRAM
This utility program is designed to work with Microsoft Windows 95.
4.2.1 Installing the Utility
CHIPSDSP.DLL is a Windows 95 based utility to select display type and refresh rate. It is a Display Properties
Refresh window that is automatically installed when installing CHIPS Windows 95 display drivers. The Display
icon is in the Control Panel group. To invoke the Display icon, simply click on the Start button, go to Settings and
click on Control Panel.
4.2.2 How to Use the Utility
DISPLAY DEVICE allows you to select the display type from the following:
•
CRT
only
C> • LCD (Flat Panel) only • Both CRT and LCD (Flat Panel) • Interlaced • 56 Hz • 60 Hz • 70 Hz • 72 Hz • 75 Hz
REFRESH RATE allows you to select the refresh rate from the following:
The refresh rate is available in CRT Mode only and only the refresh rates supported by the selected monitor will be
listed.
WINDOWS DEFAULT allows you to return to the default refresh rate setting for the selected monitor in Windows
95.