Acrosser AR-B1565 - Manual (Page 19)

AR-B1565/1565A User’s Guide
18
3.2.3 Ethernet RJ-45 Connector (LAN1, LAN2)
The Ethernet RJ-45 connectors are the standard network headers. The following table is the pin assignment.
1 8
LAN1, LAN2 FUNCTION
1 TPTX+
2 TPTX -
3 TPRX+
4 Not Used
5 Not Used
6 TPRX -
7 Not Used
8 Not Used
RJ-45 Pin Assignment
3.2.4 Keyboard & Mouse Connector (KB1)
To use the PS/2 interface, an adapter cable has to be connected to the CN3 (6-pin header type) connector. This
adapter cable is mounted on a bracket and is included in your AR-B1565/1565A package. The connector for the
PS/2 KB/mouse is a Mini-DIN 6-pin connector. Pin assignments for the PS/2 port connector are as follows:
1. MOUSE DATA
2. KB DATA
3. GND
4. VCC
5. MOUSE CLOCK
6. KB CLOCK
1 2
KB1
Figure 0-2 KB1: Keyboard & Mouse Connector
3.2.5 PS-ON Header (CN1)
1
2
3
CN1
Factory Preset
3.2.6 Reset Header (J13)
The J13 is a reset switch. Shorting these two pins will reset the system.
1
2
J13
# When AT power supplier is applied, jumper 2&3 should
be tied together.
# When ATX power supplier is applied, pin1&pin 3 should
be connect to proper location of ATX power supplier.