Acrosser AR-ES6003FL - Manual (Page 61)

Defaults (Y/N)? N
Exit
Without
Saving
Pressing on
this item for
confirmation:
Quit without saving
(Y/N)? Y
This allows you to exit Setup without storing any changes in
CMOS. The previous selections remain in effect. This shall exit
the Setup utility and restart your computer.
Set
Password
Pressing on
this item for
confirmation:
ENTER
PASSWORD:
When a password has been enabled, you will be prompted to
enter your password every time you try to enter Setup. This
prevents unauthorized persons from changing any part of your
system configuration.
Type the password, up to eight characters in length, and press
. The password typed now will clear any previous
password from the CMOS memory. You will be asked to confirm
the password. Type the password again and press . You
may also press to abort the selection and not enter a
password.
To disable a password, just press when you are
prompted to enter the password. A message will confirm that the
password will be disabled. Once the password is disabled, the
system will boot and you can enter Setup freely.
61