3DLABS Wildcat 4210 - Manual (Page 29)

22
Figure 9. Configure Monitor
Enabling Stereo Display
If you connect a device to the stereo port on the Wildcat 4210 card, you must change the display mode to
view in stereo. See Figure 5 in Chapter 2, “Setup,” for an illustration of the stereo output port.
NOTE: The Display Properties dialog box must be displayed. See “Configuring the Video Display” in
this chapter for instructions on activating the Display Properties dialog box and selecting the
Intense3D Monitor tab.
To enable stereo display:
1. Make sure your stereo display device is properly connected to the stereo output port on
the Wildcat 4210 card. See “Connecting a Stereo Display Device” in Chapter 2 for more
information.
2. On the Intense3D Monitor tab under Display Properties, click Configure Monitor. The
Configure Monitor dialog box displays (see Figure 9, above).
3. Select one of the Stereoscopic Display modes from the Display Mode pulldown, then
click OK. You are returned to the Display Properties dialog box.