3DLABS Wildcat 4210 - Manual (Page 23)

16
Connecting a Stereo Display Device
The following instructions apply only if you are connecting a stereo video display device to the Wildcat
4210 video card.
To connect a stereo display device:
1. Connect one end of the stereo emitter cable to the input port on your stereoscopic display
device.
NOTE: See the documentation delivered with your stereoscopic display device for information on the
connectors and proper cables.
2. Connect the other end of the cable to the stereo output port on the Wildcat 4210 video
card (see Figure 5).
3. Configure the display settings to enable stereo display. See Chapter 3, “Using the Video
Card,” for step-by-step instructions.
Figure 5. Wildcat 4210 Stereo Sync Output Port