3DLABS Wildcat 4210 User Manual

Page 28

Text mode
Original mode

Figure 8. Color Calibration

3. On the Intense3D Monitor Display Properties dialog box, click Configure Monitor to

change the display mode, select a monitor type, and change the resolution/refresh rate
(see Figure 9). Once you have made the changes you require, click OK to accept the new
configuration and dismiss the Configure Monitor dialog box. You are returned to the
Intense3D Monitor Display Properties dialog box.

4. Click OK on the Display Properties dialog box to accept the changes.

5. Reboot the workstation if you are prompted to do so. Most changes will take effect

without rebooting.

NOTE:

See Appendix A, “Specifications,” for a list of available monitor resolutions.

NOTE:

See “Enabling Stereo Display,” in this chapter for instructions on changing the Display Mode.

NOTE:

See “Enabling the Dual Monitor Feature under Windows 2000” later in this chapter for
instructions on configuring dual displays.