Dimplex Electralog Fireplace 7207250100R05 - Manual (Page 9)

9
Operation
minutes before switching the unit
back on.
CAUTION: If you need to
continuously reset the heater,
unplug the unit and call technical
support at 1-888-346-7539.
!
NOTE: the heater may emit
a slight, harmless odor when
first used. This odor is a normal
condition caused by initial heating
of internal heater parts and will
not occur again.
Remote Control (Figure 3)
The fireplace is supplied with an
integrated on/off remote control.
!
NOTE: Ensure that the
fireplace 3 position switch
is set to the remote control
setting (up position).
on
Button
Battery Cover
OFF
Button
Battery
Figure 3
To operate, push the ON button
to turn fireplace on, push the OFF
button to turn the fireplace off .
Remote Control Initialization/
Reprogramming
In the event that your remote
control ceases to operate your
fireplace, follow these steps to re-
initialize the hand held transmitter
and the remote control receiver in
the fireplace:
Place the 1. three Position
switch (Figure 2A) in the Off (“
O ”) position.
Wait a minimum of five (5)
2.
seconds and then place the
three Position switch in
the Remote Control (“ II ”)
position.
Within
3. 10 seconds of
changing the switch position,
press the on button located
on the remote control
transmitter (Figure 2).
this will synchronize the remote
control transmitter and the
fireplace receiver.
!
NOTE: You will have only 10
seconds to perform this last step.
Failure to do so will result in these
steps needing to be followed
again.