Normal operation – Ducane 3400 User Manual

Page 19

NORMAL OPERATION

Match Lighting Your Rotisserie Burner

Follow the simple steps listed below to match light the Rotisserie Burner of grill, in the
event electronic ignition fails:

1. Open the lid and make sure that all burners are in the “OFF” position.

ƽ DANGER: Failure to open the lid while igniting the Rotisserie

Burner, or not waiting 5 minutes to allow the gas to clear
if the Rotisserie Burner does not light, may result in an
explosive flame-up which can cause bodily injury or death.

2. Turn main gas supply on.
3. Remove warming rack. NOTE: Always remove the warming rack when using the

rotisserie.

4. Put match in the match holder and strike match.

ƽ WARNING: Do not lean over an open barbecue.

5. Push the ROTISSERIE BURNER control knob in and turn to “high”. Continue to

hold the ROTISSERIE BURNER control knob in until 20 seconds after the burner
has ignited. Then release the ROTISSERIE BURNER control knob.

6. Hold match holder and lit match to the middle of the Rotisserie Burner to ignite.

ƽ WARNING: If burner does not light, turn the selected burner

control knob to OFF and wait 5 minutes to let the gas clear
before trying again to light burner(s).

7. Verify Rotisserie Burner has ignited by visual inspection of a fl ame. (The burner will

glow red.)

Rotisserie Burner Electronic Ignition

Follow the simple steps listed below to light the Rotisserie Burner of your grill:

ƽ DANGER: Failure to open the lid while igniting the Rotisserie

Burner, or not waiting 5 minutes to allow the gas to clear
if the Rotisserie Burner does not light, may result in a
explosive flame-up which can cause bodily injury or death.

ƽ CAUTION: The Rotisserie Burner flame may be difficult to see

on a bright sunny day.

1. Open the lid and make sure that all burners are in the “OFF” position.
2. Turn main gas supply on.
3. Remove warming rack. NOTE: Always remove the warming rack when using the

rotisserie.

4. Push the ROTISSERIE BURNER control knob in and turn to “HIGH”.
5) Push in the electronic ignition button. Continue to hold the ROTISSERIE

BURNER control knob in until 20 seconds after the burner has ignited. Then
release the ROTISSERIE BURNER control knob.

6. If ignition does not occur within 5 seconds, turn control knob “OFF” and repeat

ignition step numbers 3 and 4.

7. Verify Rotisserie Burner has ignited by visual inspection of a fl ame. (The burner will

glow red.)

ƽ WARNING: If ignition still does not occur, turn control knob

OFF and wait 5 minutes before manually lighting the burner
with match. See Match Lighting instructions.

1 6