Audiovox DT 911 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
This equipment compiles with Parts 16
and 63 o( the Federal Communications
Commission (FCC) rutes for (he United
States, Operation is subject lo the
foltowing two conditions: (1) (his det/ice
may not cause interference, and ¡2)
(his
device
must
accept
any
interte ranсe, incfuding interterence that
may cause undesired operation of the
device.
A label is located on the underside of
the base unil containing either the FCC
registration
number
and
Ringer
Equivalence Number (REN). You
must, upon request, provide this
Information to your iocaf tefephone
company.
This equipment Is compati&ie with
inductively coupled hearing aids.
Should you experience trouble with
this telephone equipment, please
contact:
AUDIO VOX COMMUNICATIONS
SERVICE DEPT, at (800) 229-1335,
For repair/warranty information. The
telephone company may ask you to
disconnect this equipment trcm the lire
network until the problem has been
corrected.
FCC Part 15
Warning: Charges or modifications to
this unit not expressly approved by the
party responsibte for сотрПаг«ев could
void the user's authority to operate the
equipment.
The equipment has been tested and
found to comply with part IS of the FCC
rules. These, limits are designed lo
provide reasonable protection against
harmful interference in a residentiat
Installation. This equipment generates,
uses and can radiate radio frequency
energy and, If not installed and used
in accordance with the instructions,
may cause harmful interference to
radio commurticalions. However, there
is no guarantee that interference wilt
not occur in a particular installation. 1f
this equipment dees cause harmful
interference to radio or television
reception, which can be determined by
lurning the equipment off and on, the
user is encouraged to try and correct
the interference by one or more of the
following measures:
' Reorient or relocate Ihe receiving
antenna.
-
Increase the separation between
the equipment and receiver.
-
Connect the equipment into an
outlet or on a circuit different From
that to which the receiver is
connected.
-
Consult
the
deafer
or
an
experienced radlo/TV teehriieian
for help.
mu
&|'1VU. AM