Aiwa CT-FX929M m - Manual (Page 18)

TROUBLESHOOTING
MAINTENANCE
Error codes
In the following cases the corresponding error
code indication appears. Follow the suggestions
below to solve the problem. If the error code
indication does not disappear, consult an AIWA
service center.
ERROR01 The disc magazine is not properly
inserted in the CD changer. Reinsert
the magazine. Refer to the
instruction manual for the CD
changer.
ERROR02 No discs are ioaded in the disc
magazine. Insert discs properiy.
Refer to the instruction manuai for
the CD changer.
ERROR03 Focus error. Check that the discs
are loaded properly in the disc
magazine (right side up, etc.).
ERROR04 Problem with the CD changer. Reset
the unit by pressing the reset button.
if this does not soive the probiem,
consult an AIWA service center.
ERROR05 The CD changer is overheated.
Aliow the changer to cooi off by
moving the vehicle out of direct
sunlight.
Reset button
The Reset button is visible when you detach the
front panel. Try pressing this button if aconnected
CD changer does not operate properly. To press
this button, use the tip of a pointed object such as
a pencil or toothpick.
Note that all your setting stored in memory,
howeyer, wiil be erased by pressing this button.
Cleaning the front panel
When the front panei is soiled, wipe the surface
of the panel with a soft, dry cioth.
Cleaning the tape head
Use a cleaning cassette to clean the playback
head and capstans approximately once a month.
If the playback head is dirty, the high tones may
not be reproduced properly.
Cleaning the connector
The connector on the reyerse side of the front
panel needs to be cleaned occasionally. Wipe
the surface of the connector with a cotton swab
slightly moistened with alcohoi.
Reset button
17
ENGLISH