Destinator 6 - Manual (Page 15)

Destinator 6 13
Search for a Location
Address Modes
You can define the information used to locate an address by tapping the Mode button.
Destinator provides a variety of options for entering an address.
Town-Street This sequence provides the following address screens: Town, Street, Address
Number
For every city, you also have the option of selecting the City Center.
If you don't know address number, you can select the Street Midpoint.
Town-Street is the default format.
Street-Town This sequence provides the following address screens: Town, Street, Address
Number
This mode lets you enter a street name without having to first designate a town.
Useful when you're looking for an address in a metropolitan area where there are
many cities and towns.
Side Streets This sequence provides the following address screens: Town, Street 1, Street 2
You can locate a road junction by entering the names of two intersecting streets.
Post Code This sequence provides the following address screens: Post Code, Street, Address
Number
You can locate a street address by entering the post code, without entering a town
name. Useful when you have no information about the town.
In Other
Maps You can select another map of a country that you can travel to by vehicle.
This feature is available only when you have the following maps installed:
ƒ Map of the country where you are currently located.
ƒ Map of the country where you wish to travel.
ƒ The map of the major roads for that continent that connect one map to
another (for example, the major roads of Europe)
For example, if you are in Paris and you want to travel to Munich, select the map of
Germany and designate Munich Town Centre as your destination. Destinator
automatically displays the map of France when traveling on local roads of that
country, a map of Major Roads of Europe when traveling on a European motorway,
and the map of Germany when traveling on local roads of that country.
Address Actions
When you have specified an address, tap the Actions button to select from the following Address
commands:
Set as Origin
Lets you designate the selected location as the route origin. You would use this command when calculating a
route from a point other than your current location.
Show on Map
Lets you see the selected address on the map.