Delta 17-950L User Manual

Page 15

FIRE HAZARD. To reduce the risk of

fire, use 40 watt or less, 120 volt, reflector track type
light bulb (not supplied). DO NOT USE a stan

dard

house hold light bulb. Do not allow the reflector track-
type light bulb to extend below the lamp shade.

RISK OF PERSONAL INJURY. Disconnect

the machine from the power source before making
any adjustments.

TABLE ADJUSTMENTS

RISK OF PERSONAL INJURY. Make sure that nothing is on the table and that the workpiece is

clamped down. Falling objects can cause an injury.

You can tilt the table forward from zero (0) to 45 degrees. To adjust:

1. Loosen the two forward tilt levers (A) Fig. 23.

2. Adjust the table to your desired angle. The scale (B) Fig. 23 is located on the side of the table support.

3. Tighten the levers (A) Fig. 23.

4. A positive stop (C) Fig. 24 is provided to return the table to the zero position. Adjust this stop by turning the screw/

stop (C), located under the table. Tighten the locknut to secure the stop.

You can tilt the table right or left. Positive stops are included for 0, 45 and 90 degrees. To adjust:

1. Loosen the table bolt (E) Fig. 25 approximately 1/4 turn with the supplied 14mm hex wrench.

2. Pull out the spring-loaded detent pin (F).

3. Rotate the table to your desired angle. The tilt scale (G) Fig. 25A is located on the knuckle behind the table. Use

this scale for accuracy. You can allow the detent pin to slide in to the positive stops, but check your scale to be
sure of the exact angle.

4. Tighten the table bolt.

FLEXIBLE LAMP

The flexible lamp op er ates in de pen dent ly of the drill press. To turn the lamp “ON” and “OFF”, rotate switch (A) Fig.
22.

Fig. 22

Fig. 23

Fig. 24

Fig. 25

C Located under table

Fig. 25A