Dish Network DVR 942 - Manual (Page 14)

4
S
CANNING FOR
E
QUIPMENT
C
ODES
6 If you want to program
Limited Mode, press 1. If
not, skip to step 7.
See Limited Mode on page 3 for
more information.
7 Press POUND (#). If you entered the code
correctly, the mode button
flashes three times.
8 Press POWER to turn off
the equipment. If the equip-
ment does not turn off, go
to step 10.
If the code works, the
equipment should turn off.
9 Turn the equipment back
on and try some other but-
tons to make sure they
work. If the code works for
other buttons, stop here.
Sometimes POWER works
when other buttons don’t.
10 If the code doesn’t work,
redo steps 3 through 9 with
another equipment code
from the tables.
Try every code listed for your
brand until one works for your
equipment.
11 If you can’t find a code that
works try, Scanning for
Equipment Codes that
follows.
Instructions Additional Information
1 Turn the equipment on. Use the equipment’s front panel
buttons or its remote control.
2 Press and hold the mode
button until all the other
mode buttons light up, and
then let go of the button.
The mode button flashes.
For example, hold TV for a TV
until all of the other mode
buttons light. When you let go,
TV will flash.
Instructions Additional Information
62book.book Page 4 Tuesday, April 4, 2006 1:45 PM