Directed Electronics SR6000 - Manual (Page 6)

6 6
ddeecciiddiinngg oonn ccoom mppoonneenntt llooccaattiioonnss
SSo om mee tth hiin ng gss tto o rreem meem mb beerr aab bo ou utt m mo ou un nttiin ng g tth hee ssiirreen n::
■ Keep it away from heat sources, such as radiators, exhaust manifolds, turbochargers, and heat shields.
■ Mount it where a thief cannot easily disconnect it, whether the hood is open or shut. Both the siren and its
wires should be difficult to find. This usually involves disguising the wire to look like a factory harness.
■ We recommend against grounding the siren to its mounting screws. Instead, we recommend running both the
red and black wires into the passenger compartment and grounding to one common point for all devices. After
all, both wires are the same length and come already bonded together. Whenever possible, conceal your wires
in the factory harnesses or in the same style loom as the factory.
■ When possible, place the siren on the same side of the vehicle as the control module, where its wires will
reach the control module’s wires without extending them. Always run the wires through the center of a
grommet, never through bare metal!
■ Point the siren down so water does not collect in it.
SSo om mee tth hiin ng gss tto o rreem meem mb beerr aab bo ou utt w wh heerree tto o m mo ou un ntt tth hee cco on nttrro oll m mo od du ullee::
■ Never put the control module in the engine compartment!
■ The first step in hot-wiring a vehicle is removing the driver's side under-dash panel to access the starter and
ignition wires. If the control module is placed just behind the driver's side dash it can easily be disconnected.
■ When mounting the control module, try to find a secure location that will not require you to extend the harnesses wires
(they are 1.5 meters long). Keep it away from the heater core (or any other heat sources) and any obvious leaks.
llooccaattiioonnss ffoorr tthhee ccoonnttrrooll m moodduullee
llooccaattiioonnss ffoorr tthhee ssiirreenn