Directed Electronics SR6000 User Manual
Page 54
5
54
4
2. Was the Tach Learn successful? The LED must light solid and bright to indicate a successful learn.
3. Make sure that there is a tach signal at the purple/white tach input wire of the remote start. If there is not
a tach signal, recheck the connection to the vehicle’s tach wire and make sure the wire is not broken or
shorted to ground leading to the remote start.
■ TThhee vveehhiiccllee wwiillll ssttaarrtt,, bbuutt wwiillll oonnllyy rruunn ffoorr 1100 sseeccoonnddss..
1. Is the remote start programmed for voltage sense? Try programming the unit for low voltage reference. If this
does not work, a tach wire should be used.
2. Check diagnostics.
■ TThhee cclliim
maattee cco
on
nttrro
oll ssyysstteem
m d
do
oeess n
no
ott w
wo
orrkk w
wh
hiillee tth
hee u
un
niitt iiss o
op
peerraattiin
ng
g tth
hee vveeh
hiiccllee..
Either the wrong accessory wire is being energized or more than one ignition or accessory wire must be ener-
gized in order to operate the climate control system.