Directed Electronics SR6000 - Manual (Page 22)

2 22 2
This wire sends a negative pulse every time the remote start shuts down or the doors are locked. This can be used to
pulse the arm wire of the vehicle's factory anti-theft device. Use a relay to send a (-) or (+) pulse to the arm wire.
Connect this wire to the wire in the vehicle that sends the signal to turn on the WAIT-TO-START bulb in the dash-
board. In most diesels the wire is negative (ground turns on the bulb) and the GRAY/BLACK wire can be directly
connected to the wire in the vehicle. If the vehicle uses a positive wire (12V to turn on the bulb) a relay must
be used to change the polarity. (See Finding the Wires You Need section of this guide.) Here are some common
colors of this wire:
■ Chevrolet and GMC trucks - Light blue or dark blue
■ Ford Trucks - Black/pink
■ Dodge Ram Trucks - Orange/black or black/orange
N NO OTTEE!! A 1-amp diode must be installed in line on the factory wire between the wait-to-start indi-
cator and the ECM. (See the following diagram for details.)
H H2 2//5 5 G GR REEY Y//B BLLA ACCK K ((--)) d diieesseell w waaiitt--tto o--ssttaarrtt b bu ullb b iin np pu utt
H H2 2//4 4 G GR REEEEN N//W WH HIITTEE ((--)) ffaacctto orryy aallaarrm m rreeaarrm m