Temperature rentrel and adiusimeni, Before oporuting – Beko RBI 2301 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Temperature rentrel
and adiusimeni
Operafìng temperatures are controlìed by the
fhermoBtaf кг}оЬ (fig* 2). Settings may be
mode from Ì to 5, the coldest position.
When the appliance is switched on for the first
time, the thermostat should be adjusted so that
after 24 hours, the average fridge temperature
no higher than ¡41 T ).
We recommend setting the thermostat half way
between the 1 and 5 setting and monitoring to
obtain the desired temperature i. e. towards 5
you wii! obtain о lower temperature and vice
versa. Some sections of the fridge may be
cooier or warmer ( such os the salad crisper
and the top part of the cabinet ) which is quite
normal.
In ambient temperatures above 25°C
especioiiy in summer, turn the hermostat knob
towards 5. In ambient temperatures below
25^C (77^Fj turn the thermostat knob to a half
way position.
Frequent door opening causes internal
temperatures to rise, so it is odvisabie to
close the door os зооп as possible after use.
Before oporuting
Final Check
Before you start using the appliance check that:
1* The interior is dry and air can circulate freely
ol the rear.
2* The inferior is clean as recommended under
'^Cleaning and care/'
3. The plug has been inserted into the wail
socket and the electricity is switched on. When
the door is open the interior light will come on.
And note that:
4. You will hear a noise as the compressar
starts up. The liquid and gases sealed within
the refrigeration system may also make some
(noise), whether the compressor is running or
not. This is quite normal.
5. Slight undulation of the top of the cabinet
iS quite normal due to the manufacturing process
used; is not a defect.
6. We recommend setting the thermostat knob
midway and monitor the temperature to ensure
the appliance maintains desired storage
temperatures (See section Temperature Control
and Adjustment).
7m Do not load the appliance immediately is
switched on. Walt until the correct storage
temperature has been reached. We recommend
checking the temperature with an accurate
^^ermometer (see; Temperature Control and
Adjustment).