ASKO 7005 - Manual (Page 5)

© If you want to check how
dry the washing is:
Open the door.
© When the dryer has stopped:
The drum stops automatically
and will not restart until you close
the door and press the Start
pushbutton. dryer signals when washing is ready
When the program that has been used has finished,
the dryer stops and two signals sound.
When drying permanent press fabrics, best results will
be obtained if they are removed as soon as possibie
after the program has stopped.
• Remove the washing
• Clean the lint fiiter
• Turn off the power at the main
On/Off pushbutton switch
If the machine
does not work
The machine wili not start
Check that:
* the door is properly closed.
* the On/Off pushbutton is pressed in.
* you have set the required program or the
required time correctly.
* the electric plug is firmly inserted in its socket (if
the machine is not permanetty wired in).
* all fuses are intact.
NOTE! if the machine still fails to ^rt, it is
prdiable that the overheating cutout has
^•'«^rated. It switches off the tunrMer if the
\ dmperatureistoohi£^, forexan^sleif dusthas
blocked the lint filter. Cleem the filter and reset the
overheating protection switch by pressing the
rubber disc on the back of the machine.
The machine starts, but will not
continue to run
If the machine starts when the Start button is
pressed, but stops as soon as the button is
released, it indicates that the overheating
cutout has operated. Clean the lint filter and
allow the machie to cool down.
Excessive drying time
Check that the lint filter is not blocked. Do not
overload the dryer. Items to be tumble-dried
lUst first have been spin-dried, preferable at
00 r/min or more.
NOTE: When you start the dryer for the first
time, a slight rumbling may be heard during a
short warming-up period. When the dryer is run-
in, this sound will disappear.
' t
Filter holder
Fluff filter
Cleaning the lint filter
The lint filter must be cleaned after
each time the machine has been
used. If this is not done, drying
performance wilt suffer, as in­
sufficient air will pass through the
drum. The machine may also
overheat: this will cause it to stop
automatically.
Clean the filter as follows:
1. Grasp the filter holder by the two
holes near the center and pull it off
the peg on which it is supported in
the front door.
2. Take the filter out of the holder
and brush away the lint in it by
hand.
NOTE! Wear and tear of fabrics in a
tumble dryer is insignificant. The lint
caught in the lint filter is dust and
fiber residue that has been formed
when the garments have been used.
3. Replace the filter in the holder
and refit the holder in position on the
peg in the door.
NOTEI Clean lint collecting near the
tumble dryer as it can be sucked
into the air intake.
Other user service
About once a year, remove the
exhaust air hose and clean it and the
outlet from the machine.