Avanti BCA31SS - Manual (Page 8)

> Electrical Connection
XWarningX
improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by an authorized Avanti Products service center.
This beverage center should be properly grounded for your safety. The power cord of this beverage
center is equipped with a three-prong plug which mates with standard three prong wall outlets to
minimize the possibility of electrical shock. .
Do not under any circumstances cut or remove the third ground prong from the power cord supplied.
This beverage center requires a standard 115/120a/c-volt/60Hz electrical outlet with three-prong
ground.
The cord should be secured behind the beverage center and not left exposed or dangling to prevent
accidental injury.
Never unplug the beverage center by pulling the power cord. Always grip the plug firmly and pull
straight out from the receptacle.
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified
electrician or service technician install an outlet near the appliance
OPERATING YOUR BEVERAGE CENTER
Setting the Temperature Control
To control the internal temperature, adjust the control dial according
to the ambient temperature or purpose of use.
The first time you turn the unit on, set the temperature control to “7.
The range of the temperature control is from position "0 to 7.” After
24 to 48 hoursf^adjust the temperature control to the setting that
best suites your needs. The setting of “4" should be correct for
home or office beverage'center use
1 .Thermostat
2. Light Switch
3. LED Light
NOTE:
■ If the unit is unplugged, has lost power, or turned off; you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the beverage center will not
start.
> Interior Light
To use the interior light, switch the light either ON or OFF using the toggle switch located on the
control panel / light panel.