Avanti BCA31SS - Manual (Page 7)

Important Safety Instructions
yWARNINCy
To reduce the risk of fire, electrical shock,
or injury when using your beverage center,
follow these basic precautions:
Read all instructions before using the beverage center.
DANGER or WARNING: Risk of child entrapment.
Before you throw away your old beverage center or freezer: Take off the doors.
Leave the shelves in place so that children may not easily climb’ inside.
Never allow children to operate, play with, or crawl inside the beverage center.
Never clean beverage center parts with flammable fluids. The fumes can create a
fire hazard or explosion. .
Do not store or use gasoline or any other flammable vapors and liquids in the vicinity
of this or any other beverage center. The fumes can create a fire hazard or
explosion.
-Save these instructions-
INSTALLATION INSTRUCTIONS
Before Using Your Beverage center
• Remove the exterior and interior packing.
• Check to be sure you have all of the following parts:
• 2 Large Beverage Shelves .........^ ;
• 1 Small Beverage Shelf
1 Stainless steel Handle Assembly
• Instruction manual
• Before connecting the beverage center to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system
from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
Installation of Your Beverage center
•
This appliance is designed to be free standing only, and should not be recessed or built-in.
• Place your beverage center on a floorthat is strong enough to support the beverage center
when it is fully loaded. To level your beverage center, adjust the front legs at the bottom of the
beverage center.
• Allow 5 inches of space between the back and sides of the beverage center, which allows the
proper air circulation to cool the compressor.
• Locate the beverage center away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Extreme cold ambient temperatures may also cause the beverage
center not to perform properly.
• Avoid locating the beverage center in moist areas.
• Plug the beverage center into an exclusive, properly installed-grounded wall outlet. Do not
under any circumstances cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified electrician
or an authorized Avanti Products service center.
• After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before
placing food in the chiller or beverage center compartment.