Avanti BCA31SS - Manual (Page 4)

Before the beverage center is used, it must be properly positioned and installed as
described in this manual, so read the manual carefully. To reduce the risk of fire,
electrical shock or injury when using the beverage center, follow basic precautions,
including the following:
IMPORTANT SAFEGUIDES
A
DANGER A
Plug into a grounded 3-prong outlet, do not remove grounding prong, do not use an adapter, and
do not use an extension cord.
It Is recommended that a separate circuit, serving only your beverage center be provided. Use
receptacles that cannot be turned off by a switch or pull chain.
Never clean beverage center parts with flammable fluids. These fumes can create a fire hazard or
explosion. And do not store or use gasoline or other flammable vapors and liquids in the vicinity of
this or any other appliance. The fumes can create a fire hazard or explosion.
Before proceeding with cleaning and maintenance operations, make sure the power line of the
unit is disconnected.
Do not connect or disconnect the electric plug when your hands are wet.
Unplug the beverage center or disconnect power before cleaning or servicing. Failure to do so
can result in electrical shock or death.
Do not attempt to repair or replace any part of your beverage center unless it is specifically
recommended in this manual. All other servicing should be referred to a qualified technician.
A WARNING A
FOLLOW WARNING CALL OUTS BEL o W ONLY WHEN APPLICABLE TO YOUR MODEL
Use two or more people to move and install beverage center. Failure to do so can result in back
or other injury.
To ensure proper ventilation for your beverage center, the front of the unit must be completely
unobstructed. Choose a well-ventilated area with temperatures above 60”F (16°C) and below
90"F (32“C). This unit must be installed in an area protected from the elements, such as wind,
rain, water spray or drips.
The beverage center should not be located next to ovens, grills or other sources of high heat.
The beverage center must be installed with ail electrical, water and drain connections in
accordance with state and local codes. A standard electrical supply (115 V AC only, 60 Hz),
properly grounded In accordance with the National Electrical Code and local codes and
ordinances is required.
Do not kink or pinch the power supply cord of beverage center.
The fuse (or circuit breaker) size should be 15 amperes.
It is important for the beverage center to be leveled in order to work properly. You may need to
make several adjustments to level it.
All installation must be in accordance with local plumbing code requirements.
Make certain that the pipes are not pinched or kinked or damaged during installation.
Check for leaks after connection.
Never allow children to operate, play with or crawl inside the beverage center.
Although the unit has been tested at the factory, due to long-term transit and storage, the first
batch of cubes must be discarded.
Do not use solvent-based cleaning agents or abrasives on the interior. These cleaners may
damage or discolor the interior.
Do not use this apparatus for other than its intended purpose.