AEG FAVORIT 146 - Manual (Page 9)

Detergent Dispenser
Rinse aid
The rinse aid (liquid) is released during
the last hot rinse. It aids the drying of the
load by breaking down the water tension
allowing it to flow from the items in a sheet
rather than droplets, leaving the plates
sparkling.
An automatic rinse aid storage unit Is
fitted in the door. If you wish to try out
various rinse aids, do not fill the unit
completely the first time. The capacity of
the storage unit Is about 150 cm^.
To fill up, unscrew the filler cap (page 4,
no. 2). Fill the rinse aid container (red
centre) to the grey marking. Repiace the
filler cap. Try not to spill any rinse aid as
this may affect the next wash adversely
due to excessive foaming.
If, by any chance, rinse aid is spilled Into
the funnel between Inner and outer pipe,
the ventilation of the storage container
may get blocked and no further rinse aid
can be added. In such a case, re-tighten
filler cap and close door briefly. Then
continue with the filling.
You will find the rinse aid level indicator
on the control panel (page 3, no. 3). Refill
the rinse aid corrtalner when the ievei has
reached the lower edge of the indicator.
Rinse aid ad|uster
Depending on local water diaracteristics,
you may need to adjust the rinse aid out­
put.