AEG FAVORIT 146 - Manual (Page 5)

Installation Permanent fitting In kitchens:
Before you use your new FAVORIT dish­
washer, you should make the following
checks:
Removal of packing
During transit the outlet hose is atta-
dned to the machine at the underside,
with plastic tape. Tilt the machine badt-
wards and remove the plastic tape.
When returning the machine to its ori­
ginal position, make sure that the outlet
hose lies freely against the left hand
side of the appliance and is not crushed
on the floor. The two baskets are secu­
red by wooden blocks, inside the washer
tub.
Open the door and remove supporting
wooden blodcs and corrugated card­
board packaging.
The lower left hand basket assembly is
secured by transparent adhesive tape
inside the lower basket.
Pull off adhesive tape.
Dimensions;
With worktop
Without worktop
Height 85 cm
Width 60 cm
Depth 60 cm
Height 82 cm
Width 59.5 cm
Depth 57.5 cm
The appliance must stand level — If In
doubt use a spirit — level (maximum
permissjble deviation 2°). If necessary
adjust front feet.
Welg^i
Free standing model approx. 72 Kg net
Built-iiVunder model approx. 68 Kg net
The Appliance has adjustable feet at the
front and fixed rollers at the rear.
Seek advice from your Specialist
Retailer from whom you purchased the
appliance.
Dimensions of Decor panels
(for built-under model)
Door
Lower panel
457.5 X 589.5-radius 11
120.5 X 589.5-radius 11
Electrical connections
A. C. Current 220 V
(U. K.-version240V)
Connected load 3.4 kW
(U. K.-version 3.1 kWJ
Plus 13 amp —fused
Green and yellow Earth
Blue Neutral
Brown Live
As the colours of this mains lead of this
appliance might not correspond with the
coloured markings Identifying the ter­
minals in your plug, connect as follows:
The green and yellow wire must be
connected to the terminal In the plug
which is marked with the letter "E" or by
the earth symbol or coloured green or
green and yellow. The wire which is
coloured brown must be connected
to the terminal marked with the letter
"L" or coloured red. The wire which is
coloured blue must be connected to the
terminal with the letter "N" or coloured
black.
Wafer supply
The high pressure hose (Va" = 10 NW,
1.55 m long] with V«" hose coupling com­
plete with sealing washers Is supplied. We
recommend not to use other washers
which may be of inferior quality. It is suffi­
cient to tighten the nuts by hand but if a
spanner is used proceed very carefully.
5